dEFCONAirsoft Putting on a CIRAS vest

Putting on a CIRAS vest is a little complicated. Unfortunately my partner was not available to take photos, so for now I have done this quick guide. Hopefully in the future I can revisit this and get it done properly.

Step 1

Place your head through vest and attach the elasticised internal cummerbunds.

Step 2

lift the front MOLLE flap and wrap around the left and right cummerbunds and attach it to the front Velcro pad.

Step 3

Fasten the front MOLLE flap back down onto the Velcro pad.

Adjustments

Most aspects of the vest can be adjusted (cummerbunds, shoulder straps).

To make adjustments open the Molle flap located on the rear of the vest at the bottom.
Pull out the quick release cable and adjust each cummerbund and strap. Once done refit the quick release cable.

Back to main article.

All material within is copyright dEFCONAirsoft 2007. dEFCONAirsoft is kindly sponsored by Fire-Support. Some of the views expressed within these pages are not necessarily the views of dEFCONAirsoft or any of the sites affiliated with us.