Snow Wolf SW-11 Replacement Wire Component
£12.99
This SNOW internal wiring assembly suits SW-11 series repairs in a workshop setting, replacing damaged loom and terminal parts with factory routing. Technicians wanting a straight swap without cutting or soldering will find it matches the original layout.
In stock
Free Shipping on Orders Over £200
- UK Based
- Over 15 Years in Business
- No-Hassle Returns
- 5 Star Customer Service
Description
The SNOW SW-11 replacement wire component is a factory replacement wiring assembly for the SW-11 series. It is intended for workshop gunsmiths and field technicians who need to correct wiring faults or internal linkage failures and bring a replica back to its standard operating state without modifying the surrounding assembly. It is a repair part for restoring baseline operation rather than a change to the setup of the replica.
The assembly uses high-conductivity insulated copper wiring terminated with reinforced connection terminals. Routing is pre-measured for drop-in fitment, so no structural cutting or soldering adjustment is required during installation. Tolerances are held close so current delivery stays steady under cyclic operational load. Each part carries the identification code 616064, which can be matched against the original before fitting.
- Factory replacement internal part for the SW-11 series
- Insulated copper wiring with reinforced terminals
- Pre-measured drop-in routing, no cutting or soldering
- Built to close tolerances for stable current under cyclic load
- Part identification code: 616064
